BS ISO 21308-2 pdf download – Road vehicles-Productdata exchange between chassis andbodywork manufacturers(BEP)— Part 2 : Dimensional body work exchange parameters.
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 612. ISO 1176, Iso 7656, ISO 21308-3, and the folowing definitions apply.
3.1
BEP-code
code to identity a unque meas4iremont on the truck, to make the information exchange between chassis manufacturers and bodywork manufacturers easier without any confusion with other systems
NOTE BEP is an abbreviation of Bodywork Exchange Parameter
3-2
left and right side
left side m the driving direction and right side in the driving direction
3-3
driven axle
driven axle marked with an X in the drawings
3.4
non-driven axle
axle. such as steered or tag axle, marked with an 0 wi the drawings
3,5
front edge
most forward point of the truck as delivered from the chassis manufacturer
NOTE Usually, the front edge is the bunEer.
3.6
gross vehicle mass
GVM
gross vehicle weight
GVW
technical or legal gross vehicle mass lweightj according to the legislation or regulations br me applicaoie region
NOTE See aleo ISO 2t308-3 and ISO IllS.
4 Coding system
4.1 General
Each dimension given in this part of ISO 21306 is assigned a code. composed of the items given below.
4.2 BEP code
A prefix BER, followed by a dash (-), shall be used to avoid confusion with other coding systems
4.3 Type of dImension
Dimension codes are used to denote length. width and height measurements along the zero X-. N’- a 2- planes respectively, as defined In ISO 4130. They are also used to denote angle measurements.
– S-Sparewtteel;
— T—Toolbox:
— U—Urea tank,
4.5 Code assignment and description
Clauses 5, 6, and 7 of this part of ISO 21306 show the assignment of each BE P-code together with a
description of its applicability and limitations.
4.6 Priority
The column Pflority shows the priority of the measurements, as follows:
— A — Essential:
— B—Useful.
4.7 LoadIng condition
The column Loading shows the load situation of the chassis, as follows:
— I — Unladen;
— 2— Laden (design mass.
NOTE A dash (-) mearie that the field not applicable.
4.8 Presented in
The column Presented ln describes in which type of document the Items can be presented, as follows:
— 20— 2D drawing;
– 30-3D model:
– TD — Technical data sheet
NOTE An empty field means that there is no specific recommendation fOr the presentation. It can be covered by any kind of document. A sh (•) me that the field is not appacable.
BS ISO 21308-2 pdf download – Road vehicles-Productdata exchange between chassis andbodywork manufacturers(BEP)— Part 2 : Dimensional body work exchange parameters
